You are not logged in or registered. Please login or register to use the full functionality of this board...
RMW Forums
RMW BVH.............3 left out of 10 - Printable Version

+- RMW Forums (http://revolutionmini.com/forum)
+-- Forum: RMW (/forumdisplay.php?fid=1)
+--- Forum: Announcements (/forumdisplay.php?fid=24)
+---- Forum: RMW ANNOUNCEMENTS (/forumdisplay.php?fid=35)
+---- Thread: RMW BVH.............3 left out of 10 (/showthread.php?tid=1662)

Pages: 1 2

RMW BVH.............3 left out of 10 - Jan - 08-15-2013 05:16 PM

get them while you canTongue

1st come, 1st served!

RE: RMW BVH.............3 left out of 10 - ColinGreene - 08-15-2013 06:13 PM

Calling Thumper GP

RE: RMW BVH.............3 left out of 10 - Jan - 08-15-2013 06:17 PM

Normally we charge $200 for the CNC'd intake manifold
anyone sending in their intake manifold will get a discount down to $150 for port matched CNC

RE: RMW BVH.............3 left out of 10 - Dave.0 - 08-15-2013 06:42 PM

Mendra you need a BVH.

RE: RMW BVH.............3 left out of 10 - ColinGreene - 08-16-2013 03:42 AM

him too..

RE: RMW BVH.............3 left out of 10 - Mendra72 - 08-16-2013 07:08 AM

Dave - my BVH will come with a whole motor attached.

(08-15-2013 06:42 PM)Dave.0 Wrote:  Mendra you need a BVH.


RE: RMW BVH.............3 left out of 10 - ColinGreene - 08-16-2013 07:16 AM

Wellzy needs one pretty bad as well....

RE: RMW BVH.............3 left out of 10 - Shanne - 08-16-2013 08:47 AM

(08-16-2013 07:08 AM)Mendra72 Wrote:  Dave - my BVH will come with a whole motor attached.

(08-15-2013 06:42 PM)Dave.0 Wrote:  Mendra you need a BVH.

haha

RE: RMW BVH.............3 left out of 10 - Dave.0 - 08-16-2013 01:30 PM

(08-16-2013 07:08 AM)Mendra72 Wrote:  Dave - my BVH will come with a whole motor attached.

(08-15-2013 06:42 PM)Dave.0 Wrote:  Mendra you need a BVH.

Niiiiiice buddy

RE: RMW BVH.............3 left out of 10 - scolburn79 - 08-16-2013 10:03 PM

(08-15-2013 06:17 PM)Jan Wrote:  Normally we charge $200 for the CNC'd intake manifold
anyone sending in their intake manifold will get a discount down to $150 for port matched CNC

What sort of gains would you be looking at with your port matched intake manifold on your head jan? Will this be compatible with the TVS when it becomes available?