+- RMW Forums (http://revolutionmini.com/forum)
+-- Forum: RMW (/forumdisplay.php?fid=1)
+--- Forum: Announcements (/forumdisplay.php?fid=24)
+---- Forum: Vendor Announcements (/forumdisplay.php?fid=25)
+---- Thread: Aquamist HFS-3 and MINI Tank GB (/showthread.php?tid=237)
RE: Aquamist HFS-3 and MINI Tank GB - ThumperGP - 09-11-2011 11:56 AM
Going to the dyno on Thursday for the first time since downpipe and the Aquamist....
Very curious to see where its at.
RE: Aquamist HFS-3 and MINI Tank GB - silhouette88 - 09-11-2011 12:12 PM
Can't wait to see your numbers! I thought your boost cuts were making dyno runs prohibitive?
RE: Aquamist HFS-3 and MINI Tank GB - ThumperGP - 09-11-2011 12:27 PM
(09-11-2011 12:12 PM)silhouette88 Wrote: Can't wait to see your numbers! I thought your boost cuts were making dyno runs prohibitive?
Haven't had one in a while....we shall see though...
RE: Aquamist HFS-3 and MINI Tank GB - Buli - 09-11-2011 03:12 PM
What is the best way to run the gauge wire from one foot well to the other?
btw I am installing the kit. A lot a work. I should be less picky about what quality of job I do, but I can't.
Under car and hood is done. Boot is hooked up but panels are still out. Gauge mounted, installing JCW shift indicator at the same time.
RE: Aquamist HFS-3 and MINI Tank GB - ColinGreene - 09-11-2011 03:21 PM
Its seriously not very hard to do, just tuck it into the edge of the carpet.
RE: Aquamist HFS-3 and MINI Tank GB - ThumperGP - 09-11-2011 03:47 PM
(09-11-2011 03:12 PM)Buli Wrote: What is the best way to run the gauge wire from one foot well to the other?
btw I am installing the kit. A lot a work. I should be less picky about what quality of job I do, but I can't.
Under car and hood is done. Boot is hooked up but panels are still out. Gauge mounted, installing JCW shift indicator at the same time.
Assuming u have it in the glovebox, run it out the back of the glovebox and down along the center console/foot well. Bring it across the center console, underneath the little open area below the A/C controls...then up the otherside. Not the best explanation, but its really not hard to figure out if u stare in that area.
RE: Aquamist HFS-3 and MINI Tank GB - Buli - 09-11-2011 04:13 PM
Got it thanks!
RE: Aquamist HFS-3 and MINI Tank GB - HbSean - 09-11-2011 04:38 PM
Anyone try to put it in the small storage above the glovebox?
RE: Aquamist HFS-3 and MINI Tank GB - BostonR56S - 09-11-2011 04:41 PM
There isn't a great amount of room to route things through there. It can be done, but I cut the sht out of my hands wiring my head unit up there when I used to have it up there. A good place to out it is behind the padding under the carpet on the footwell back wall, look up to the top of the carpeting, about where your toes would be if sitting in the passenger seat with your feet pointed up.
I have my iPod control module there, and my laser jammer computer.
RE: Aquamist HFS-3 and MINI Tank GB - HbSean - 09-11-2011 04:53 PM
Lol, yes I meant the control box.. I seem to remember someone doing it just can't find that post.