C38...........is it possible? - Printable Version +- RMW Forums (http://revolutionmini.com/forum) +-- Forum: ROTREX Superchargers (/forumdisplay.php?fid=66) +--- Forum: Rotrex kits (/forumdisplay.php?fid=67) +--- Thread: C38...........is it possible? (/showthread.php?tid=813) |
RE: C38...........is it possible? - ColinGreene - 02-18-2014 02:50 PM Im sure someone has a one we can measure, and get the info to post up. Did you read the thread that got Andrea banned? he actually brought you up quite a bit.... RE: C38...........is it possible? - Aluminius - 02-18-2014 03:13 PM Well, I didn't follow this thread for long. The last post I remember was the one Shanne explained tuning basics, like full lean at 2 bar makes tons of power, lol ... Just realised that 134mm instead of 139mm moves my redline from 7300 to 7600 rpm!!! ... And I never know Andrea ruined another engine. We talk on FB from time to time and I know he's got some problems with one sleeve protruded into cooling chamber but that sounds not that bad. RE: C38...........is it possible? - Shanne - 02-18-2014 03:25 PM (02-18-2014 03:13 PM)Aluminius Wrote: Well, I didn't follow this thread for long. The last post I remember was the one Shanne explained tuning basics, like full lean at 2 bar makes tons of power, lol lol C38...........is it possible? - eurowned - 02-18-2014 04:49 PM Aluminus check this out... RE: C38...........is it possible? - Shanne - 02-18-2014 06:11 PM OHNOZ IS DAT THE WATERZ JACKETZ RE: C38...........is it possible? - eurowned - 02-18-2014 06:19 PM Shanne I am afraid so...OH NOEZ RE: C38...........is it possible? - ColinGreene - 02-18-2014 06:41 PM This clearly looks like certain failure. RE: C38...........is it possible? - Jan - 02-18-2014 07:38 PM Stock crank pulley is 136.5mm RE: C38...........is it possible? - Aluminius - 02-19-2014 04:49 AM eurowned, what engine is that?! Thanx, Jan RE: C38...........is it possible? - eurowned - 02-19-2014 10:53 AM (02-19-2014 04:49 AM)Aluminius Wrote: eurowned, what engine is that?! ERL Performance Super-Deck wet sleeve Chevrolet LS7 V8. |