+- RMW Forums (http://revolutionmini.com/forum)
+-- Forum: RMW (/forumdisplay.php?fid=1)
+--- Forum: Announcements (/forumdisplay.php?fid=24)
+---- Forum: Vendor Announcements (/forumdisplay.php?fid=25)
+---- Thread: Aquamist HFS-3 and MINI Tank GB (/showthread.php?tid=237)
Aquamist HFS-3 and MINI Tank GB - LASRGUY - 11-06-2011 12:07 PM
Posted results from my first dyno tune with Jan in the 2nd gen dyno room. I was running a 0.7mm jet and about 90/10 meth/water. 258ftlbs and 226hp.
RE: Aquamist HFS-3 and MINI Tank GB - BlrdFx - 11-06-2011 12:13 PM
Looks like good numbers! And that all happened with 10 percent Meth????
RE: Aquamist HFS-3 and MINI Tank GB - Guest - 11-06-2011 12:15 PM
Dumb question here: but do you have to run a mix?
I mean, is it dependent on the individual car/setup?
RE: Aquamist HFS-3 and MINI Tank GB - Jan - 11-06-2011 12:26 PM
probably best on R56 to run at least 80% meth
RE: Aquamist HFS-3 and MINI Tank GB - Guest - 11-06-2011 12:29 PM
(11-06-2011 12:26 PM)Jan Wrote: probably best on R56 to run at least 80% meth
Gotcha.
RE: Aquamist HFS-3 and MINI Tank GB - HbSean - 11-06-2011 01:12 PM
Any tips on Tapping the boost tube? Looks like it would be a pita to take it off
RE: Aquamist HFS-3 and MINI Tank GB - Buli - 11-06-2011 01:25 PM
(11-06-2011 01:12 PM)HbSean Wrote: Any tips on Tapping the boost tube? Looks like it would be a pita to take it off
I did it per Jeff's instructions.
Aquamist HFS-3 and MINI Tank GB - LASRGUY - 11-06-2011 01:25 PM
Sorry. It was 90/10 meth/water. I had previously run 50/50, drained most of it and filled with straight meth.
RE: Aquamist HFS-3 and MINI Tank GB - HbSean - 11-06-2011 01:30 PM
(11-06-2011 01:25 PM)Buli Wrote:(11-06-2011 01:12 PM)HbSean Wrote: Any tips on Tapping the boost tube? Looks like it would be a pita to take it off
I did it per Jeff's instructions.
Take the hard pipe off? Im not sure how to get to it.. ill lift the car up and see if I can get to it from under it
RE: Aquamist HFS-3 and MINI Tank GB - Buli - 11-06-2011 01:33 PM
(11-06-2011 01:30 PM)HbSean Wrote:(11-06-2011 01:25 PM)Buli Wrote:(11-06-2011 01:12 PM)HbSean Wrote: Any tips on Tapping the boost tube? Looks like it would be a pita to take it off
I did it per Jeff's instructions.
Take the hard pipe off? Im not sure how to get to it.. ill lift the car up and see if I can get to it from under it
Nope, don't take off the hard pipe. Disconnect from FMIC, and take out the IAT sensor or disconnect at the hard pipe to rubber pipe. Tap and blow it out.