Threaded Mode | Linear Mode

LASRGUY · (This post was last modified: 11-06-2011 01:26 PM by LASRGUY.)

Posted results from my first dyno tune with Jan in the 2nd gen dyno room. I was running a 0.7mm jet and about 90/10 meth/water. 258ftlbs and 226hp.

BlrdFx · 11-06-2011, 12:13 PM

Looks like good numbers! And that all happened with 10 percent Meth????

11-06-2011, 12:15 PM

Dumb question here: but do you have to run a mix?
I mean, is it dependent on the individual car/setup?

***Jan*** · 11-06-2011, 12:26 PM

probably best on R56 to run at least 80% meth

11-06-2011, 12:29 PM

(11-06-2011 12:26 PM)Jan Wrote: probably best on R56 to run at least 80% meth

Gotcha.

HbSean · 11-06-2011, 01:12 PM

Any tips on Tapping the boost tube? Looks like it would be a pita to take it off

Buli · 11-06-2011, 01:25 PM

(11-06-2011 01:12 PM)HbSean Wrote: Any tips on Tapping the boost tube? Looks like it would be a pita to take it off

I did it per Jeff's instructions.

LASRGUY · 11-06-2011, 01:25 PM

Sorry. It was 90/10 meth/water. I had previously run 50/50, drained most of it and filled with straight meth.

HbSean · 11-06-2011, 01:30 PM

(11-06-2011 01:25 PM)Buli Wrote:
(11-06-2011 01:12 PM)HbSean Wrote: Any tips on Tapping the boost tube? Looks like it would be a pita to take it off

I did it per Jeff's instructions.

Take the hard pipe off? Im not sure how to get to it.. ill lift the car up and see if I can get to it from under it

Buli · 11-06-2011, 01:33 PM

(11-06-2011 01:30 PM)HbSean Wrote:
(11-06-2011 01:25 PM)Buli Wrote:
(11-06-2011 01:12 PM)HbSean Wrote: Any tips on Tapping the boost tube? Looks like it would be a pita to take it off

I did it per Jeff's instructions.

Take the hard pipe off? Im not sure how to get to it.. ill lift the car up and see if I can get to it from under it

Nope, don't take off the hard pipe. Disconnect from FMIC, and take out the IAT sensor or disconnect at the hard pipe to rubber pipe. Tap and blow it out.