Threaded Mode | Linear Mode

RennSport Racing · 11-13-2011, 09:38 PM

Yes, it usually happens when the threshold is down below 12 o'clock. I'm not sure where the flow sensor is, I'll check when I get back to the car.

You have photos of my install don't you jeff?

**Howerton Engineering** · 11-13-2011, 09:39 PM

(11-13-2011 09:38 PM)etalj Wrote: Yes, it usually happens when the threshold is down below 12 o'clock. I'm not sure where the flow sensor is, I'll check when I get back to the car.

You have photos of my install don't you jeff?

Yeah, I looked and may have saved a couple, I'll look.

**Howerton Engineering** · 11-14-2011, 07:51 PM

Sent two CV's out today.

BostonR56S · 11-14-2011, 10:40 PM

(11-14-2011 07:51 PM)Howerton Engineering Wrote: Sent two CV's out today.

Thanks. Will keep you updated.

**Howerton Engineering** · 11-15-2011, 09:37 PM

I was going to start a new thread for this but we'll give it a go here. Now that the bulk of the MINI stuff is slowing down, what do we need to revise in the R56 manual? Anything that would have been more helpful? Anything we need a a better pic of? I'm sure we won't get everything perfect, but I'm hoping to do only one major revision instead of tinkering with it multiple times.

If you can be specific to what was unclear and in what part of the manual(page number) that would help.

Thanks.

***ColinGreene*** · 11-15-2011, 09:43 PM

i found it pretty reasonable

**Howerton Engineering** · 11-15-2011, 09:47 PM

(11-15-2011 09:43 PM)ColinGreene Wrote: i found it pretty reasonable

You didn't take all of the calls I did. lol

***ColinGreene*** · 11-15-2011, 09:48 PM

True. Its probably because I'm the Doogie Howser of meth kits?

Buli · 11-15-2011, 10:01 PM

Sent PM.

BostonR56S · 11-15-2011, 10:05 PM

Dont have the page number with me but the photo of the FAV shows the wire pointing upwards when mounted, upon clarification with you the wire should be pointed down to catching water. Not a big deal, but small detail since I used the photos a lot to help me assemble pieces.

Might want to point out the fuse may not be installed on the tank/pump assembly? Lol just going for the obvious ones here. Overall it was very good and helpful.