Threaded Mode | Linear Mode

Batrugger · 08-19-2011, 06:38 PM

The GTT looks really nice, but the Canton costs less and actually cleans up pretty nice. We've had ours on for over three years after blowing through two of the stckers:

[Image: IMG_9153.jpg]

***Jan*** · 08-19-2011, 07:23 PM

looking good

**Howerton Engineering** · 08-20-2011, 08:54 AM

Since Canton won't actually make the products in their catalog, here's the generic I quickly fitted last weekend. I need to cleanup where I cut off the upper bracket and such but it fits pretty nicely in the space. The top hose is the stock unit just relocated to the front side of the PS tank, when I get an urge to tear it apart again I'll route the a new hose properly.
I'm not hot on the finish or sticker either,, I'm considering sending it to the powder coater in one of our product batches to put a finish on it to match the valve cover.

Mike S · 08-21-2011, 01:15 AM

That actually looks really good! I'm a fan Big Grin

Just put in another hose so if you have overflow it won't ruin your engine bay's neatness.

Luai · 08-21-2011, 05:02 AM

Jeff is this one is smaller than the OEM one? If it is, does it matter?

Mike S · 08-21-2011, 10:39 AM

(08-21-2011 05:02 AM)Luai Wrote: Jeff is this one is smaller than the OEM one? If it is, does it matter?

It is smaller Luai, but it won't make a difference in flow.

**Howerton Engineering** · 08-21-2011, 10:45 AM

Yes, it's smaller but hasn't seemed to be an issue. I'm thinking of ordering a second and asking them to put the upper bung on the opposite side of the tank so it matches up with the factory hoses. That and the black power coat would make it a slick replacement. Cost was only $75.