Vipec pre-order signup!

[Shanne]

(01-20-2012 03:09 PM)HRM Wrote:  I don't want to rain on the parade, but I was going to buy the MXT-L and wanted it, but found some negative reviews and followed them even to the innovate forums. Some guys had three new ones all showing errors and this was very recently. Seems maybe that they had a bad batch, or there is a flaw in the design, but there were too many bad reviews and I ended up getting a butt ugly LT1 kit on ebay for $168 or so. It is digital, comes in red or blue, but I really want it for the output for the vipec and the place I have for it is under the center console so no one will see the butt ugliness. I am just too lazy to mess with this and traded the better looking new one for the butt ugly old one with a solid track record.

After I ordered, on the Vipec forum, I found them recommending a different brand, but I was depressed I already bought one so I ignored it, but it was somewhere on the forum. The innovate will certainly work fine.

Just a heads up.

(01-20-2012 09:44 AM)Mutant_Tractor Wrote:  Can you buy JUST the wideband without the gauge, have it run into the ViPEC and then use your own software to display it?

From what I understood reading on the forums and install manual, the vipec needs the output from the gauge itself. There was some contradictory data, but that is what I decided they were saying. Best ask others, but that was my read.

Yeah some company's have bad batches of stuff sometimes. I will get mine and test it and see how it goes. I love my LC-1. Thanks for the heads up though.

As far as the cable. It depends on the wideband. If its a good one it will have a 0-5v feed coming off. If its cheap...good luck. My LC-1 it comes off the wideband wires itself, the MTX-L it comes off the gauge as its one unit. The AEM UGEO I also believe comes off the gauge. Its all tied in though....need less to say as long as you get a good wideband you are going to have a 5V feed on it....


HRM what were the problems they were having with them?