Vipec pre-order signup!

[Mendra72]

Wideband is heated and I grounded the gauge it connects with to the block already. I will try and locate the correct wire on the stock O2 harness, however I need to be able to swap back the ECU to pass smog - so what do you suggest ?

(03-17-2012 12:45 PM)LeeRR Wrote:  You can use the stock wiring cable that is already into the ECU?

---

Locate the O2 hardness down the right side of the block. The sender is the yellow cable on my 05 MCS. You need to find power and ground for the wideban obviously (if it's heated like my LC-1 is) but that will be picked up by the VIPEC from that location. Saves you having to pin into extra aux ports