|
Here is how to wire Electric Water pump to Vipec
|
|
05-23-2012, 10:33 PM
Post: #1
|
|||
|
|||
|
Here is how to wire Electric Water pump to Vipec
This is using WIDEBAND instead of factory o2 sensors
pin 85 of relay is the ground control for relay take pin 85 to o2 engine harness connector pin 3 vipec settings are o2 sensor heater = injector 5 GP output condition 1 only SW condition 1 = ECT> 85C Sw condition 2= ECT< 80c So in this case: pump will start running at 85c and shut off after it drops below 80c  You can set these where you like this is just an example. Then setting the fan to help keep the water temps where you like You should never underestimate the predictability of stupidity "Tuning Matters" minimark Wrote: ....as silent as a freshly fallen snow on a crisp winter morning, a deafening hush falls across the land of Kool-Aid..... ![[Image: 76V0TaO.png?1]](http://i.imgur.com/76V0TaO.png?1) |
|||
|
|
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)