Here is how to wire Electric Water pump to Vipec

Threaded Mode | Linear Mode

Here is how to wire Electric Water pump to Vipec

05-23-2012, 10:46 PM

Post: #3

Jan

Holder of the Ban Stick

Posts: 7,360
Joined: May 2011
Reputation: 7

RE: Here is how to wire Electric Water pump to Vipec

(05-23-2012 10:42 PM)colingreene Wrote: Are you using the 02 sensor pin as the water pump controller? is that how i read that.
Sorry if that seems like a dumb question, i'm stuck in a hospital right now and i'm pretty tired.

by configuring the Vipec the way I posted will provide a ground in the Vipec for the water pump to come on when the water temp in the head gets past 85c and takes the ground away when it goes below the lower limit.

Since you are NOT using the heaters for the o2 sensors (not in car) you can configure it as a GP output to run the water pump. If you don't have Meth hooked to AUX1 on the auxiliary harness you could have just run it to that instead.

Either way the issue is fixed Wink

You should never underestimate the predictability of stupidity

"Tuning Matters"

minimark Wrote:
....as silent as a freshly fallen snow on a crisp winter morning, a deafening hush falls across the land of Kool-Aid.....