Aquamist HFS-3 and MINI Tank GB

[ThumperGP]

(08-03-2011 09:36 PM)Buli Wrote:  Any suggestions on the best place to install the jet?

I think you have a 56....

Ideally you want it just after the intercooler. This allows the most amount of time for the mist to be vaporized and heat to be absorbed from the intake tract. It will also allow the T-MAP to see the cooler temps and the ECU should adjust timing accordingly. I actually have mine just after the MAP sensor, up closer to the throttle body/intake manifold....just because install wise, it was the easiest to do. Even where I have mine...the results have been awesome. Even though you are getting less intake air cooling, you are still getting maximum combustion chamber cooling and increased octane.

That said, I do plan on moving it further down to test the difference...but just have not had a chance to take out the pipe and drill it.