|
Here is how to wire Electric Water pump to Vipec
|
|
09-27-2013, 08:12 PM
Post: #12
|
|||
|
|||
|
RE: Here is how to wire Electric Water pump to Vipec
pin 85 of relay is the ground control for relay
take pin 85 to o2 engine harness connector pin 3 vipec settings are o2 sensor heater = injector 5 GP output condition 1 only SW condition 1 = ECT> 85C Sw condition 2= ECT< 80c You should never underestimate the predictability of stupidity "Tuning Matters" minimark Wrote: ....as silent as a freshly fallen snow on a crisp winter morning, a deafening hush falls across the land of Kool-Aid..... ![[Image: 76V0TaO.png?1]](http://i.imgur.com/76V0TaO.png?1) |
|||
|
|
« Next Oldest | Next Newest »
|
User(s) browsing this thread: 1 Guest(s)