Aquamist HFS-3 and MINI Tank GB

[Buli]

(09-01-2011 11:09 AM)silhouette88 Wrote:  

(09-01-2011 11:02 AM)Buli Wrote:  So when it came on, did you go into limp mode?

No, I don't have the failsafe wires tapped in so it wouldn't. But even if I did it shouldn't because there's still a good amount of fluid in the tank when the led comes on. I mean good amount as in, if you drive it nice (like I was) you shouldn't have to worry about it running out and sucking air, and tripping the failsafe.

So it would not go into failsafe from the level switch, but it will from flow outside of expected. If you had it hooked up. Correct?

---

(09-01-2011 11:13 AM)ThumperMCS Wrote:  I also don't have my failsafe wires tapped...I don't see the point until you get tuned for meth.

I thinking was that the ECU would self tune/adjust to it. I know if I switch from 93 to 91 octane I get knock at idle for a while. I sure wouldn't want to get knock at high rpm from going from the high octane with the meth to low if the meth stopped flowing. That was how I was thinking it might work, and why I will hook the failsafe from the start.