|
Here is how to wire Electric Water pump to Vipec
|
|
06-28-2016, 11:01 PM
Post: #14
|
|||
|
|||
|
RE: Here is how to wire Electric Water pump to Vipec
LC1
Brown wire on o2 sensor harness goes to YELLOW wire of ENGINE harness for front (stock o2 sensor) plug by valve cover LC2 Yellow wire to yellow wire pin 85 of relay is the ground control for relay take pin 85 to o2 engine harness connector pin 3 vipec settings are o2 sensor heater = injector 5 GP output condition 1 only SW condition 1 = ECT> 85C Sw condition 2= ECT< 80c You should never underestimate the predictability of stupidity "Tuning Matters" minimark Wrote: ....as silent as a freshly fallen snow on a crisp winter morning, a deafening hush falls across the land of Kool-Aid..... ![[Image: 76V0TaO.png?1]](http://i.imgur.com/76V0TaO.png?1) |
|||
|
|
« Next Oldest | Next Newest »
|
User(s) browsing this thread: