Aquamist HFS-3 and MINI Tank GB

[ThumperGP]

(09-11-2011 03:12 PM)Buli Wrote:  What is the best way to run the gauge wire from one foot well to the other?

btw I am installing the kit. A lot a work. I should be less picky about what quality of job I do, but I can't.

Under car and hood is done. Boot is hooked up but panels are still out. Gauge mounted, installing JCW shift indicator at the same time.

Assuming u have it in the glovebox, run it out the back of the glovebox and down along the center console/foot well. Bring it across the center console, underneath the little open area below the A/C controls...then up the otherside. Not the best explanation, but its really not hard to figure out if u stare in that area.