Aquamist HFS-3 and MINI Tank GB

[Buli]

(09-12-2011 10:35 PM)Howerton Engineering Wrote:  

(09-12-2011 10:27 PM)Buli Wrote:  I would like the turn on to be softer. It comes on so quick and I can see a blip on my HP.

You can do this a few different ways.

1) Put the restrictor in to help cut the mid-range IDC.

2) Bring the system on earlier, turning the THRES down to bring less spray on sooner.

This is part of the tuning process for each car and setup. The balance of jetting, restrictor, GAIN and THRES as well as pump pressure can change the dynamic of the system.

If you really like all the spray up top, you could even go to the .9mm jet, with the largest restrictor to cut the low end down some, and turn the GAIN down a bit.

Tomorrow after work I plan on installing the restrictor. I will start the THRES earlier too.