Aquamist HFS-3 and MINI Tank GB

[killerfox]

you will not need any oil for tapping plastic. What I did was to remove the upper hose going to the throttle body and put my shop vac hose in it, make sure you remove the map sensor first. After I was finished I left the hose off and started the car in the hopes that the boost would blow out anything that the shop vac didn't get, then hook up the hose. You may have to clear a few codes from not having the hose on.

(09-15-2011 12:48 PM)BostonR56S Wrote:  Got it thanks. I've tapped plenty of metal, but never plastic haha.
I'm worried about getting plastic chips into the tract, but planning on using a bit of oil and a shop vac in the hose underneath to help as much as possible to avoid it. I don't really want to remove the whole bumper to get that whole pipe out.