Aquamist HFS-3 and MINI Tank GB

[RennSport Racing]

(10-04-2011 06:04 AM)Buli Wrote:  

(10-04-2011 12:04 AM)etalj Wrote:  My wheel speed sensor is throwing a fault now (even though the actual sensors are fine). I think it's the ecu tapping I did.

If you wired the "optional" boost cut, as I did
move the jumper from DR0 to DR1 and leave it that way always
Then move the jumper from DHB to DFS during setup and testing.
Move back when you have it all working and want to enable the failsafe.

Edit: Failed reading comprehension, too early no coffee.

I didn't wire the wastegate failsafe

(10-04-2011 08:59 AM)BostonR56S Wrote:  

(10-04-2011 12:04 AM)etalj Wrote:  My wheel speed sensor is throwing a fault now (even though the actual sensors are fine). I think it's the ecu tapping I did.

Are you lowered? I know lowering caused something to rub against my speed sensor wire exposing the wires. When it rained, all my abs/brake/etc lights lit up on the dash. taped it up and zip tied it out of the way, been OK since. I know you said the sensor is fine, but just double check the wire coming off of it in the wheel well i suppse if you havent.

I'm getting a bit worried, everyone seems to have "random" issues occuring coincidently after tapping their ECU. =\

I'm lowered, but the issue only started after the water/meth install. I'm sure it has something to do with the install, as I checked the wheel speed sensors, and they aren't fouling on anything.

Pretty bummed tbh