Aquamist HFS-3 and MINI Tank GB

[BostonR56S]

(09-23-2011 06:05 PM)silhouette88 Wrote:  

(09-22-2011 05:06 PM)BostonR56S Wrote:  Tomorrow after work will be the real install. I expect to get everything wired. Will just need to tap the hole after that.

Update?

Ran the loom from the trunk to the engine bay. Omg was that a bitch on a jack stand and a car that's been in the rain all day. Got wet AND sore from twisting in every direction (c'mon I set it up perfectly, insert jokes!!). The rest should be easy, I've been in and out of that rubber hole so many times now( insert another). Lol, aka the firewall grommet. Trunk is all set. Just gotta wire controller wires, tap ecu, mount flow sensor, and tap holes. Btw couldn't find the tap at home depot.... Where'd u guys get yours

---

R u positive you tapped the right ecu wires and fuse?

(09-23-2011 06:16 PM)LASRGUY Wrote:  

(09-23-2011 02:50 PM)ThumperMCS Wrote:  An R56 on a flatbed......

Go figure.


Sorry to hear man!

Things just got worse. I talked to Motoring Magic (local shop) and they said it looks like something called the "switch control module" seems to be bad and it is $700 just for the part. They're worried about putting in a new one in case it is somehow related to my install. This is really sucking the excitement out of my water/meth upgrade...